Power-Sonic

Dispositivos Soportados

Device Type	Modbus TCP (Ethernet)	RS485	Curtailment
PS-PULSE-INV-6KW	❌	✅	❌
PS-PULSE-INV-8KW
PS-PULSE-INV-10KW
PS-PULSE-INV-12KW

Cableado

RS485

RS485 Wiring

• For correct RS485 wiring: Follow the guidelines for RS485 wiring.
• If the wiring shown in the table below is incorrect, please let us know.
• There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
	RS485 A	RS485_POS	RS485 A	TX+
	RS485 B	RS485_NEG	RS485 B	TX-
	RS GND	GND	Not available	G

Configuración

NOTE: RS485 Device Addresses

• You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
• Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
• For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.

1. Establezca el modo de trabajo en Autoconsumo

2. Establezca Exportación Cero en Desactivar

3. Establezca Control Remoto en Habilitar

4. Establezca la dirección RS485. La tasa de baudios predeterminada es 9600, si no, configúrela en 9600.

5. Establezca la corriente de carga. Establezca la corriente de carga.

IMPORTANTE!

Para un 5KT configúrelo en 100 Para un 10KT configúrelo en 160

6. Establezca AC Acoplar en Habilitar