Power-Sonic

Appareils Supportés

Device Type	Modbus TCP (Ethernet)	RS485	Curtailment
PS-PULSE-INV-6KW	❌	✅	❌
PS-PULSE-INV-8KW
PS-PULSE-INV-10KW
PS-PULSE-INV-12KW

Câblage

RS485

RS485 Wiring

• For correct RS485 wiring: Follow the guidelines for RS485 wiring.
• If the wiring shown in the table below is incorrect, please let us know.
• There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
	RS485 A	RS485_POS	RS485 A	TX+
	RS485 B	RS485_NEG	RS485 B	TX-
	RS GND	GND	Not available	G

Configuration

NOTE: RS485 Device Addresses

• You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
• Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
• For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.

1. Réglez le mode de fonctionnement sur Autoconsommation

2. Réglez l'exportation à zéro sur Désactiver

3. Réglez le Contrôle À Distance sur Activer

4. Réglez l'adresse RS485. Le débit en bauds par défaut est de 9600, sinon, réglez-le à 9600.

5. Réglez le courant de charge. Réglez le courant de charge.

IMPORTANT !

Pour un 5KT, réglez-le sur 100 Pour un 10KT, réglez-le sur 160

6. Réglez AC Couple sur Activer