मुख्य कंटेंट तक स्किप करें

AC•THOR / AC ELWA 2

1. Basic settings on the my-PV device​

First read the installation and user manual supplied with the device, as well as the online manual.

  • The user manual for AC•THOR can be found here
  • The user manual for AC ELWA 2 can be found here
  • Make sure the device is correctly installed and connected before proceeding.

2. Settings on the my-PV device​

Configure the following parameters in the web interface or via my-PV Cloud:

SettingValue / Comment
Control sourceModbus TCP
Power time-out60 seconds
AC•THOR AC ELWA 2

These settings can be applied directly on the device, via the web interface, or through my-PV Cloud.

3. Network & communication​

  1. The AC•THOR or AC ELWA 2 devices are connected to ENIRIS Smartgrid One through your local network (router).
  2. Within this network, the my-PV device receives commands indicating how much power it should deliver.
Notes & Limitations
  • A maximum of 10 my-PV devices can be controlled within a single network.
  • The operating mode M3 is not supported in this configuration.
  • Do not connect the my-PV device directly to the inverter or battery system — control must occur via the network.

4. Settings on ENIRIS Smartgrid One​

Perform the following steps in the web interface of ENIRIS Smartgrid One:

Step 1: Select the device type​

You will be asked: "What kind of device do you want to add?"

Step 2: Select the manufacturer​

Choose MYPV from the list of manufacturers.

Step 3: Select the model​

You will be asked: "Which device model are you adding?"
Select the correct model, for example:

  • AC Elwa 2
  • Acthor
  • Acthor 9s

Step 4 & 5: Network & communication​

ENIRIS Smartgrid One will perform a network scan. In the "Device network parameters" screen, you can add the device:

  • Option 1: Add by MAC address (recommended for networks with DHCP)
  • Option 2: Add by fixed IP address, domain, or hostname

Step 6: Configure the device settings​

In the "Device/group settings" screen, configure the specific settings for the my-PV device.

SettingExample valueComment
Is the device single or three phase?Single phaseSelect the correct phase configuration
Normal power (W)[device-specific]Nominal power of the my-PV device
Operating voltageSame as the main deviceOperating voltage
Normal voltage typePhase-neutralSelect voltage type (Phase-neutral or Phase-phase)
Normal voltage (V)2300Nominal voltage in Volts (e.g. 230V × 10)

Don’t forget to click the Save button at the bottom of the page.