Supported Devices
The SolarEdge Grid API driver works at site level:
once the gateway is connected, all inverters registered on the same SolarEdge monitoring site become visible.
Below are the models we frequently encounter – any other SolarEdge inverter should behave identically.
| Device Type |
|---|
| HD-Wave single-phase (SE3000–SE7600) |
| Three-phase (SE9K–SE33.3K) |
| Commercial Synergy (SE66K / SE100K) |
Configuration steps
Prerequisite: your SolarEdge site must already send data to the SolarEdge monitoring portal (
monitoring.solaredge.com).
-
Sharing the Site
- Share the SolarEdge installation with solaredge@eniris.io to allow external control.
-
Add in SmartgridOne
- Contact SmartgridOne regarding the addition of a new site.
Inverter Control
The inverters can be controlled by setting the maximum power to a percentage of the inverter's nominal power.
dica
If a SolarEdge Grid Meter is connected to the inverter, the inverter can be set to self-consumption. This ensures that no energy is injected back into the grid, but enough is produced to compensate for consumption.