انتقل إلى المحتوى الرئيسي

توصيل RS485 لسلسلة Autarco LQH

logo

تصف هذه الصفحة الاتصال مع عاكس هجين من سلسلة Autarco LqH عبر Modbus-RTU (rs485). بشكل افتراضي، يتم تعيين العاكس على العنوان 1. يحدث الاتصال RS485 عبر واجهة RJ45 الموجودة في أسفل العاكس خلف لوحة واقية. يتم وضع العلامات على الموقع الدقيق في المربع البرتقالي في الصورة أدناه:

Image

تعريف دبابيس منفذ RS485 هو كالتالي (EIA/TIA 568B):

  • RS485A على دبوس 5: أزرق/أبيض
  • RS485B على دبوس 4: أزرق
Image
NOTE: RS485 Device Addresses
  • You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
  • Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
  • For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.

بعد اتصال RS485 ناجح والتواصل مع SmartgridOne Controller عبر بروتوكول Modbus-RTU، سيظهر الآن العاكس Autarco أيقونة زرقاء جديدة على لوحة مؤشر الحالة الخاصة به:

logo