محولات هايبوينتيك
الأجهزة المدعومة
| Device Type | Variants | RS485 |
|---|---|---|
| محول طاقة شمسية متصل بالشبكة، ذو طور واحد | HPK 1000/1500/2000/2500/3000, HPS 3000D/3680D/4000D/5000D/6000D, HPS 3000P/3680P/4000P/5000P/6000P | ✅ |
| محول طاقة شمسية متصل بالشبكة، ذو ثلاثة أطوار | HPT 3000P/4000P/5000P/6000P/8000P/10000P/12000P/15000P, HPT 15KP/20KP/25KP/30KP, HPT 15K/17K/20K/22K/25K, HPT 30K/33K/36K/40K/50K, HPT 60K/70K/80K | |
| محول هجيني | HES 3000/3680/4000/5000/6000, HHS 3000/3680/4000/5000/6000, HHT 5000/6000/8000/10000/12000/15000 |
معلومات
لم يتم اختبار هذه التكاملات مع جميع الأجهزة المذكورة أعلاه، ومع ذلك، بما أنها تستخدم نفس بروتوكول التواصل، ينبغي أن تعمل دون مشاكل.
الأسلاك
يتواصل SmartgridOne Controller ومحولات هايبوينتيك عبر RS485.
RS485
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | SmartgridOne Controller model OM1 | SmartgridOne Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| RS485A (الدبوس 3) | RS485 A | RS485_POS | RS485 A | TX+ |
| RS485B (الدبوس 4) | RS485 B | RS485_NEG | RS485 B | TX- |
| غير قابل للتطب يق | RS GND | GND | Not available | G |
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.