UrządzeniaEnergy meterSolis
Liczniki energii Solis podłączone do sieci
Obsługiwane urządzenia
| Device Type | Modbus TCP (Ethernet) | RS485 |
|---|---|---|
| Solis Grid-Tie Meter (via Inverter/EPM) | ✅ | ✅ |
| Autarco Grid-Tie Meter (via Inverter/EPM) |
Połączenie
Ethernet
Aby poprawnie podłączyć ethernet: Postępuj zgodnie z wytycznymi dotyczącymi okablowania ethernetowego.
RS485
Podłącz kable RS485 do portu komunikacyjnego urządzenia Solis (Inwerter lub Menedżer Mocy Eksportowanej).
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | SmartgridOne Controller model OM1 | SmartgridOne Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| A | RS485 A | RS485_POS | RS485 A | TX+ |
| B | RS485 B | RS485_NEG | RS485 B | TX- |
| GND (opcjonalnie) | RS GND | GND | Not available | G |
Konfiguracja
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.
Upewnij się, że urządzenie jest skonfigurowane z następującymi ustawieniami Modbus, aby pasowały do specyfikacji sterownika:
- Prędkość transmisji: 9600
- Bity danych: 8
- Bity stopu: 1
- Parzystość: Brak
- Adres Modbus: 1 (domyślny) - Zakres: 1 do 254
