Cabeamento RS485 da série Autarco LQ | SmartgridOne Documentation

Esta página descreve a comunicação com um inversor híbrido da série Autarco LQ via Modbus-RTU (rs485). Por padrão, o inversor está configurado para o endereço 1. A interface RS485 é um conector de 4 pinos na parte inferior do inversor atrás de uma placa protetora. A posição exata está marcada na caixa laranja na imagem abaixo:

Observando mais de perto, a porta se apresenta assim:

Deve ser utilizado um conector apropriado para esse conector de 4 pinos no inversor Autarco para conectar ao SmartgridOne Controller. No SmartgridOne Controller, o inversor pode ser conectado à porta RS485. A fiação é a seguinte:

RS485 Wiring

For correct RS485 wiring: Follow the guidelines for RS485 wiring.
If the wiring shown in the table below is incorrect, please let us know.
There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
Pin 3	RS485 A	RS485_POS	RS485 A	TX+
Pin 4	RS485 B	RS485_NEG	RS485 B	TX-
N/A	RS GND	GND	Not available	G

NOTE: RS485 Device Addresses

You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.

Observando mais de perto, a porta se apresenta assim:

RS485 Wiring

For correct RS485 wiring: Follow the guidelines for RS485 wiring.
If the wiring shown in the table below is incorrect, please let us know.
There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
Pin 3	RS485 A	RS485_POS	RS485 A	TX+
Pin 4	RS485 B	RS485_NEG	RS485 B	TX-
N/A	RS GND	GND	Not available	G

NOTE: RS485 Device Addresses

You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.