توصيل الأسلاك للموديل Autarco LH-series RS485

تصف هذه الصفحة التواصل مع العاكس الهجين من سلسلة Autarco LH عبر Modbus-RTU (rs485). بشكل افتراضي، يتم ضبط العاكس على العنوان 1. واجهة RS485 هي موصل 4 دبابيس يسمى "COM" يقع في الجزء السفلي من العاكس وراء لوحة حماية. الموقع الدقيق موضح في المربع البرتقالي في الصورة أدناه:

عند النظر عن قرب، يبدو المنفذ هكذا:

يجب استخدام موصل مناسب لهذا الموصل ذو الأربعة دبابيس على عاكس Autarco للاتصال بـ SmartgridOne Controller. على SmartgridOne Controller، يمكن توصيل العاكس بمنفذ RS485. التوصيل الكهربائي كالتالي:

RS485 Wiring

For correct RS485 wiring: Follow the guidelines for RS485 wiring.
If the wiring shown in the table below is incorrect, please let us know.
There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
Pin 3	RS485 A	RS485_POS	RS485 A	TX+
Pin 4	RS485 B	RS485_NEG	RS485 B	TX-
N/A	RS GND	GND	Not available	G

NOTE: RS485 Device Addresses

You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.

عند النظر عن قرب، يبدو المنفذ هكذا:

RS485 Wiring

For correct RS485 wiring: Follow the guidelines for RS485 wiring.
If the wiring shown in the table below is incorrect, please let us know.
There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.

Device	SmartgridOne Controller model OM1	SmartgridOne Controller model IG8	RS485-USB converter	RS485-Ethernet converter
Pin 3	RS485 A	RS485_POS	RS485 A	TX+
Pin 4	RS485 B	RS485_NEG	RS485 B	TX-
N/A	RS GND	GND	Not available	G

NOTE: RS485 Device Addresses

You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.