Sunwoda
Dispositivos Soportados
| Device Type | Modbus TCP (Ethernet) | RS485 | Curtailment |
|---|---|---|---|
| OSP-100K-A | ✅ | ✅ | ❌ |
| OSP-200K-A | |||
| OSP-200K-A2 | |||
| OSP-300K-A3 | |||
| OSP-400K-A2 | |||
| OSP-400K-A4 | |||
| OSP-100K-B | |||
| OSP-200K-B | |||
| OSP-200K-B2 | |||
| OSP-100K-C-2 | |||
| OSP-100K-C-3 | |||
| OSP-200K-C | |||
| OSP-200K-C2 | |||
| OSP-100K-H-2 | |||
| OSP-100K-H-3 | |||
| OSP-200K-H | |||
| OSP-200K-H2 | |||
| Oasis 180 |
Precaución
Precaución
Importante para baterías mayores a 100 kW
Si la potencia de su batería es de 100 kW o más, contacte al soporte de Sunwoda para ampliar el registro de limitación de potencia.
Por defecto, la limitación de potencia está establecida en 100 kW. Esto puede ser actualizado por el soporte de Sunwoda en el registro 0x78f6. SmartgridOne Controller entonces podrán controlar la limitación de potencia.
Cableado
Ethernet
Para un cableado ethernet correcto: Siga las .
RS485
Info
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | SmartgridOne Controller model OM1 | SmartgridOne Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| RS485 A | RS485_POS | RS485 A | TX+ | |
| RS485 B | RS485_NEG | RS485 B | TX- | |
| RS GND | GND | Not available | G |
Configuración
Si se conecta a través de TCP, asegúrese de que el dispositivo esté configurado para comunicarse con el puerto 502.
Advertencia
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.